Form

Thank you for choosing Sydney Stone as your document finishing equipment supplier. To ensure your new equipment is installed quickly and efficiently, our Technical Services installation team requires information about where you want your equipment installed or removed.

We would be grateful if you would take some time to complete the site survey details below and return it to us as soon as possible. If you would like additional guidance or further clarification on any issue, please call our Technical Services helpdesk at 1-800 668 6055 (Local 416-251 6546)

Company name*

Address*

Equipment to be Installed

Equipment to be Removed

Is vehicle unloading point a loading dock or ground level?

Which floor of your building will the equipment be installed on

If required, is an elevator available?

Internal dimensions, door width & capacity of elevator

Is there alternate access?

Dimensions and nature of access

Doors or openings: Please provide the height & width of the narrowest and lowest opening between vehicle unloading point and installation site

Are there any steps or obstacles to negotiate? If yes, please give full details of step number, height, up or down, any landings

Are there any ramps? If yes, please estimate the grade up or down

What is the condition and construction of the access floor(s) between vehicle unloading point and installation site?

Are there any special obstructions between vehicle unloading point and installation site such as radiators, pipes, electrical conduits etc. If yes, What are they?

Is there any parking or access restrictions to your premises? ___________ If yes, you are responsible to inform all local authorities, police etc. and obtain permission for our vehicle to stop or park whilst unloading.

If required, are you able to provide physical manpower to assist with unpacking or moving of the equipment?

Will operator training be required at time of installation? If yes, how many operators require training

Operating Hours?

Training is provided for up to 4 (four) operators. Additional operators will be charged at our hourly rate.

Most of our equipment connects to an 115v power outlet, some requires a 220v single or three phase power supply. We will notify you prior to installation of the requirements. It is your responsibility to supply the required power including the correct receptacle as advised by us or a qualified electrician at time of installation. Please supply a simple sketch (if you think it would help) of the route from/to the vehicle unloading point from/to the installation site.

Thank you for completing this site survey. Installation/removal cannot take place until this survey has been received by us. Please note that, if in the opinion of Sydney R Stone, the installation/removal is non-standard, requiring additional labour, excessive time or the hire of specialist equipment, we reserve the right to retrospectively charge you, at cost, for these services.

Declaration: I, the undersigned, confirm the access route for the intended installation/removal of the equipment is of sufficient load bearing capacity and is structurally sound. I accept that Sydney R Stone may, at its discretion, charge me for any abortive attempt to install/remove the equipment due to inaccurate or inadequate information supplied in this site survey.

First name*

Last name*

Phone number*

Email*

Date*

Year/Month/Day